MIL-DTL-5675C
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as follows:
a. First article inspection (see 4.5).
b. Conformance inspection (see 4.3 ).
4.2 Inspection conditions. Unless otherwise specified, all inspections shall be performed in accordance
with the applicable test procedures.
4.3 Conformance inspection. All finished shackles shall be carefully examined to determine conformance
problems with the specification with respect to workmanship, form, and dimensions.
4.4 Responsibility for compliance. All items shall meet all requirements of sections 3, 4, and 5. The
inspection set forth in this specification shall become a part of the contractor's overall inspection system
or quality program. The absence of any inspection requirements in the specification shall not relieve the
contractor of the responsibility of ensuring that all products or supplies submitted to the Government for
acceptance comply with all requirements of the contract. Sampling inspection, as part of manufacturing
operations, is an acceptable practice to ascertain conformance to requirements, however, this does not
authorize submission of known defective material, either indicated or actual, nor does it commit the
Government to accept defective material.
4.4.1 Lot records. Manufacturers shall keep lot records for 3 years minimum. Manufacturers shall
monitor for compliance to the prescribed procedures, and observe that satisfactory manufacturing
conditions and records on lots are maintained for these thimbles. The records, including as a minimum,
an attributes summary of all quality conformance inspections conducted on each lot, shall be available to
review by customers at all times.
4.5 First article inspection. First article inspection, if not done by the manufacturer, shall be performed at a
laboratory acceptable to the procuring activity on sample units produced with equipment and procedures
used in production.
4.6 Samples for first article. Samples for first article shall be representative of the products proposed to
be furnished to this specification. Sampling shall be in accordance with 4.8.2.1.
4.7. First article inspection routine. All samples shall be subjected to first article testing in accordance
with table II. Sequence is manufacturing's discretion.
TABLE II. First article inspection.
Inspection
Requirement
Test method
Visual and mechanical inspections
Salt spray testing
Finish
Grade A shackles plating
Grade B & C shackles corrosion
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business