MS16843G
Part or Identifying Number (PIN) example:
MS16843 -1 Z1 L
Specification sheet number
Size dash number for pipe end (see figure 1) Protective coating
Left lay helical grooves when required
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. 8idders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
.
Referenced documents. In addition to FF-C-450, this document references the following: ASTM-A153/A153M
ASTM-8117
ASTM-8633
ASTM-8695
SAE AMS-QQ-P-416
SAE J403
CONCLUDING MATERIAL
Custodians: Preparing activity: Army - AR DLA - CC
Navy - SH
Air Force - 99
DLA - CC
Review activities:
Army - AT, AV, CR4, GL Navy - MC, SA, YD
Air Force - 71
(Project 4030-2012-003)
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business