MS20115B
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Break sharp edges, and remove all hanging burrs and slivers.
4. Unless otherwise specified tolerances: decimals ±.010 (0.25 mm).
5. Holes to be co-axial within ±.005 (0.13 mm).
FIGURE 1. Shackle dimensions and configurations - Continued. REQUIREMENTS:
Dimensions and configuration shall be in accordance with figure 1.
For design features purposes, this standard takes precedence over documents referenced herein. Referenced documents shall be of the issue in effect on date of invitation for bid.
Materials and finishes shall be in accordance with MIL-DTL-5675, see table I for material code.
TABLE I. Material and code letters.
Code letter |
Material |
- |
Corrosion resistant steel (CRES) |
F |
Steel |
K |
Nickel-copper-aluminum alloy |
PIN: The PIN consists of prefix "MS" the specification sheet number, a letter or dash number for material code, and size number. Unassigned PIN's shall not be used.
MS 20115 - 8
Size designator (see figure 1)
Material code letter (see table I) Specification sheet number
MS prefix
PIN example: MS20115-8 indicates a CRES shackle for 1/4 inch (6.35 mm) wire rope.
Marking: Part shall be permanently marked with the MS PIN, and include the manufacturers CAGE, name, or trademark.
Changes from previous issues. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.
Referenced documents. This document references MIL-DTL-5675.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business